DYNAMICS OF MECHANICAL MACHINING WITH END MILLS ON CNC MACHINE

Main Article Content

N. POPOK
V. ANISIMOV

Abstract

Increasing the productivity of processing complex-profile surfaces of parts is considered and power efficiency of CNC machine drives by using end mills with steep cutting edges. Dependences of changes in cutting forces on time and processing modes using milling cutters from various manufacturers are given.

Article Details

How to Cite
POPOK, N., & ANISIMOV, V. (2024). DYNAMICS OF MECHANICAL MACHINING WITH END MILLS ON CNC MACHINE. Vestnik of Polotsk State University. Part B. Industry. Applied Sciences, (1), 28-34. https://doi.org/10.52928/2070-1616-2024-49-1-28-34
Author Biography

N. POPOK, Euphrosyne Polotskaya State University of Polotsk

д-р техн. наук, проф.

References

Granovskii, G.I. (1948). Kinematika rezaniya. Moscow: Mashgiz. (In Russ.)

Bobrov, V.F. (1962). Vliyanie ugla naklona glavnoi rezhushchei kromki instrumenta na protsess rezaniya metallov. Moscow: Mashgiz. (In Russ.)

Konovalov, E.G., Sidorenko, V.A. & Sous', A.V. (1972). Progressivnye skhemy rotatsionnogo rezaniya metallov. Minsk: Nauka i tekhnika. (In Russ.)

Yashcheritsin, P.I., Borisenko, A.V., Drivotin, I.G. & Lebedev, V.Ya. (1987). Rotatsionnoe rezanie materialov. Minsk: Nauka i tekhnika. (In Russ.)

Popok, N.N. & Anisimov, V.S. (2019). Kinematika obrabotki poverkhnostei detalei vrashchayushchimsya rezhushchim instrumentom s kasatel'nym dvizheniem rezhushchei kromki [Kinematics of processing surfaces of parts with a rotating cutting tool with tangential movement of the cutting edge]. Vestnik Polotskogo gosudarstvennogo universiteta. Seriya V. Promyshlennost'. Prikladnye nauki [Herald of Polotsk State University. Series B. Industry. Applied Science], 11, 31–38. (In Russ., abstr. in Engl.)

Popok, N.N. & Anisimov, V.S. (2020). Deformatsiya i struzhkoobrazovanie pri obrabotke ploskikh i krivolineinykh poverkhnostei detalei vrashchayushchimsya rezhushchim instrumentom na tokarnykh i frezernykh stankakh s ChPU [Deformation and chip formation when processing flat and curved surfaces of parts with a rotating cutting tool on cnc lathes and milling machines]. Vestnik Polotskogo gosudarstvennogo universiteta. Seriya V. Promyshlennost'. Prikladnye nauki [Herald of Polotsk State University. Series B. Industry. Applied Science], 3, 28–34. (In Russ., abstr. in Engl.)

Most read articles by the same author(s)

<< < 1 2 3 > >>