THE CHOICE OF MATERIAL FOR THE RESTORATION OF GROSS SURFACING IN VIEW OF ITS PHYSICAL AND MECHANICAL PROPERTIES
Article Sidebar
Main Article Content
Abstract
In the article the results of the analysis of the chemical composition of the materials used for the restoration of the shafts of medium carbon steel welding are presented. Theoretical dependence of the axial deformation of the weld shaft of the elastic modulus, the heating temperature and the temperature coefficient of linear expansion of the materials recovered products and coatings, bead size, on the basis of which it is possible to predict the change in the axial dimension of the shaft and limit the number of weld overlays are obtained. Decisive influence on the residual stresses have a heating temperature of the coating material and the temperature coefficient of linear expansion. To a lesser extent affected by the ratio values of the modulus of elasticity of the coating and the workpiece material.
Article Details

This work is licensed under a Creative Commons Attribution 4.0 International License.
V. IVANOU, Polotsk State University
д-р техн. наук, проф.
А. KASTRUK, Polotsk State University
канд. техн. наук, доц.
Т. VIGERINA, Polotsk State University
канд. техн. наук
References
Ярошевич, В.К. Коленчатые валы автомобильных двигателей / В.К. Ярошевич, М.А. Белоцерковский, Е.Л. Савич. – Минск: БНТУ, 2004. – 176 с.
Сидоров, А.И. Восстановление коленчатых валов тракторных двигателей плазменной наплавкой / А.И. Сидоров, К.А. Ильясов // Сварочное производство. – 1983. – № 4. – С. 38–40.
Бурумкулов, Ф.Х. Оценка триботехнических характеристик коленчатых валов, восстановленных установкой полуколец / Ф.Х. Бурумкулов, В.Е. Блох // Труды ГОСНИТИ / ГОСНИТИ. – М., 1992. – Т. 92: Восстановление деталей и техническое обслуживание машин, используемых в сельском хозяйстве. – С. 3–25.
Восстановление деталей машин: справочник / Ф.И. Пантелеенко [и др.], под ред. В.П. Иванова. – М.: Машиностроение, 2003. – 672 с.
Лившиц, Л.С. Металловедение сварки и термическая обработка сварных соединений / Л.С. Лившиц, А.Н. Хакимов. – 2-е изд., перераб. и доп. – М.: Машиностроение, 1989. – 336 с.
Вигерина, Т.В. Влияние наплавки на длину коленчатого вала при восстановлении / Т.В. Вигерина // Вестник БНТУ. – 2011. – № 6. – С. 14–18.