COMPLEX MINERAL ADDITIVE BASED ON INDUSTRIAL WASTE FOR GYPSUM BINDERS

Main Article Content

А. KATULSKAYA
L. PARFENOVA

Abstract

The paper presents the results of studies of a two-component mineral additive based on industrial waste for a gypsum binder. The compositions of the complex additive are considered with the combination of two components: bypass dust and defecate, bypass dust and sludge of water treatment. The effect of a complex additive on the gypsum stone microstructure is shown. The timing of setting of a gypsum binder, as well as water absorption and strength characteristics of gypsum stone at the age of 7 and 28 days are determined. It was found that the combined introduction of bypass dust and sludge of water treatment can increase bending strength, compressive strength. It was found that the introduction of defecate in combination with bypass dust slows down the setting time of the gypsum binder, provide reduction in water absorption and times compression strength.

Article Details

How to Cite
KATULSKAYA А., & PARFENOVA, L. (2019). COMPLEX MINERAL ADDITIVE BASED ON INDUSTRIAL WASTE FOR GYPSUM BINDERS. Vestnik of Polotsk State University. Part F. Constructions. Applied Sciences, (16), 24-29. Retrieved from https://journals.psu.by/constructions/article/view/309
Author Biography

L. PARFENOVA, Полоцкий государственный университет

канд. техн. наук, доц.

References

Gliksman, L.R. Heat transfer in foams / L.R. Gliksman, N.C. Hilyard ; A. Cumingham (eds.) // Low density cellular plastics Springer. – Dordrecht, 1994. – P. 104–152.

Coquard, R. Numerical investigation of conductive heat transfer in high porosity foams / R. Coquard, D. Baillis // Acta Materialia. – 2009. – № 57. – P. 5466–5479.

Thermal insulation materials made of rigid polyurethane foam (PUR/DIR) : Report № 1 (October) / BING : Federation of Europen Rigid Polyurethane Foam Associations. – Brussels, 2006. – 33 p.

Nikitsin, V.I. Determination of capillary tortuosity coefficient in calculations of moisture transfer in building materials / V.I. Nikitsin, B. Backiel-Brzozowska // Heat Mass Transfer. – 2013. – № 56. – P. 30–34.

Sheffer, G.A. A whole range hygric material model : Modelling liquid and vapour transport properties in porous media / G.A. Sheffer // Heat Mass Transfer. – 2010. – Vol. 53. – P. 286–296.

Epstein, N. On tortuosity and the tortuosity factor in flow and diffusion through porous media / N. Epstein // Chemical Engineering Science. – 1989. – Vol. 44, № 3. – P. 777–779.

Mendes, M. An improved model for the effective conductivity of open-cell porous foams / M. Mendes, S. Ray, D. Trimis // Heat Mass Transfer. – 2014. – Vol. 75. – P. 224–230.

Uncertainty in the thermal conductivity of insulation materials / F. Dominguez-Munoz [et al.] // Building Simulation : мaterials of XI International IBPSA Conference, Glasgow, 27–30 July 2009. – Glasgow, 2009. – Р. 1008–1013.

Most read articles by the same author(s)