KINEMATIC AND TECHNOLOGICAL SUPPORT FOR FORMING THE REGULAR MICRORELIEF OF SPHERICAL SURFACES OF PARTS BY COMBINED CUTTING WITH CUTTING
Article Sidebar
Main Article Content
Abstract
The kinematic features of the processing of spherical surfaces by a rotating tool at a high cutting speed, the formation of a cutting surface and a cut layer, and the angles of the blade in the cutting process are analyzed. The results of experimental studies of the physical characteristics of the cut sheet, microrelief and microhardness of the resulting surface of the component are presented, including after coating with TiN by the ion-plasma method, confirming a decrease in the height of irregularities and an increase in microhardness in comparison with the traditional methods of obtaining spherical surfaces.
Article Details
This work is licensed under a Creative Commons Attribution 4.0 International License.
N. POPOK, Polotsk State University
д-р техн. наук, проф.
V. KUKAREKO, The Joint Institute of Mechanical Engineering of the National Academy of Sciences of Belarus
д-р техн. наук, проф.
References
Справочник по триботехнике : в 3 т. / под общ. ред. М. Хебды, А.В. Чичинадзе. – М. : Машиностроение, 1989. – Т. 1 : Теоретические основы. – 400 с.
Шнейдер, Ю.Г. Эксплуатационные свойства деталей с регулярным микрорельефом / Ю.Г. Шнейдер. – 2-е изд. перераб. и доп. – Л. : Машиностроение, Ленингр. отд-ние, 1982. – 248 с.
Чистосердов, П.С. Комбинированные инструменты для отделочно-упрочняющей обработки / П.С. Чис-тосердов. – Минск : Беларусь, 1977. – 127 с.
Анализ способов обработки сферических поверхностей / Н.Н. Попок [и др.] // Вестн. Полоц. гос. ун-та. Сер. В, Прикладные науки. Промышленность. – 2006. – № 12. – С. 42–45.
Попок, Н.Н. Ионно-лучевая обработка материалов азотом / Н.Н. Попок, С.В. Дербуш // Оборудова-ние и инструмент для профессионалов : междунар. информ.-техн. журн. – 2009. – № 6. – С. 18–19.
Металлорежущие вращающиеся инструменты и оснастка : каталог Sandvik Coromant, 2015.
Попок, Н.Н. Шероховатость поверхности детали при обработке ротационным инструментом с преры-вистой режущей кромкой / Н.Н. Попок // Машиностроение : сб. – Минск, 1990. – Вып. 15. – С. 18–22.